MSE0=value1, MSE3=value1, MSE1=value1, MSE2=value1, SUSCFG=value1, MSDE=value1, PRBC=value1, PCIS=value1
Global Control Register
| PRBC | Prescaler Clear Configuration 0 (value1): SW only 1 (value2): GSTATThe register contains the status of the prescaler and each timer slice (idle mode or running)…PRB and prescaler registers are cleared when the Run Bit of CC40 is cleared. 2 (value3): GSTATThe register contains the status of the prescaler and each timer slice (idle mode or running)…PRB and prescaler registers are cleared when the Run Bit of CC41 is cleared. 3 (value4): GSTATThe register contains the status of the prescaler and each timer slice (idle mode or running)…PRB and prescaler registers are cleared when the Run Bit of CC42 is cleared. 4 (value5): GSTATThe register contains the status of the prescaler and each timer slice (idle mode or running)…PRB and prescaler registers are cleared when the Run Bit of CC43 is cleared. |
| PCIS | Prescaler Input Clock Selection 0 (value1): Module clock 1 (value2): CCU4x.ECLKA 2 (value3): CCU4x.ECLKB 3 (value4): CCU4x.ECLKC |
| SUSCFG | Suspend Mode Configuration 0 (value1): Suspend request ignored. The module never enters in suspend 1 (value2): Stops all the running slices immediately. Safe stop is not applied. 2 (value3): Stops the block immediately and clamps all the outputs to PASSIVE state. Safe stop is applied. 3 (value4): Waits for the roll over of each slice to stop and clamp the slices outputs. Safe stop is applied. |
| MSE0 | Slice 0 Multi Channel shadow transfer enable 0 (value1): Shadow transfer can only be requested by SW 1 (value2): Shadow transfer can be requested via SW and via the CCU4x.MCSS input. |
| MSE1 | Slice 1 Multi Channel shadow transfer enable 0 (value1): Shadow transfer can only be requested by SW 1 (value2): Shadow transfer can be requested via SW and via the CCU4x.MCSS input. |
| MSE2 | Slice 2 Multi Channel shadow transfer enable 0 (value1): Shadow transfer can only be requested by SW 1 (value2): Shadow transfer can be requested via SW and via the CCU4x.MCSS input. |
| MSE3 | Slice 3 Multi Channel shadow transfer enable 0 (value1): Shadow transfer can only be requested by SW 1 (value2): Shadow transfer can be requested via SW and via the CCU4x.MCSS input. |
| MSDE | Multi Channel shadow transfer request configuration 0 (value1): Only the shadow transfer for period and compare values is requested 1 (value2): Shadow transfer for the compare, period and prescaler compare values is requested 3 (value4): Shadow transfer for the compare, period, prescaler and dither compare values is requested |