ANAEN=value1, DATMOD=value1, MULDIV=value1, SCALE=value1, TRIGMOD=value1
DAC0 Configuration Register 1
| SCALE | Scale value for up- or downscale of the DAC0 input data in steps by the power of 2 (=shift operation) 0 (value1): no shift = multiplication/division by 1 1 (value2): shift by 1 = multiplication/division by 2 2 (value3): shift by 2 = multiplication/division by 4 3 (value4): shift left by 3 = multiplication/division by 8 4 (value5): shift left by 4 = multiplication/division by 16 5 (value6): shift left by 5 = multiplication/division by 32 6 (value7): shift left by 6 = multiplication/division by 64 7 (value8): shift left by 7 = multiplication/division by 128 |
| MULDIV | Switch between up- and downscale of the DAC0 input data values 0 (value1): downscale = division (shift SCALE positions to the right) 1 (value2): upscale = multiplication (shift SCALE positions to the left) |
| OFFS | 8-bit offset value addition |
| TRIGSEL | Selects one of the eight external trigger sources for DAC0 |
| DATMOD | Switch between independent or simultaneous DAC mode and select the input data register for DAC0 and DAC1 0 (value1): independent data handling - process data from DATA0 register (bits 11:0) to DAC0 and data from DATA1 register (bits 11:0) to DAC1 1 (value2): simultaneous data handling - process data from DAC01 register to both DACs (bits 11:0 to DAC0 and bits 23:12 to DAC1). |
| SWTRIG | Software Trigger |
| TRIGMOD | Select the trigger source for channel 0 0 (value1): internal Trigger (integer divided clock - see FREQ parameter) 1 (value2): external Trigger (preselected trigger by TRIGSEL parameter) 2 (value3): software Trigger (see SWTRIG parameter) |
| ANACFG | DAC0 analog configuration/calibration parameters |
| ANAEN | Enable analog DAC for channel 0 0 (value1): DAC0 is set to standby (analog output only) 1 (value2): enable DAC0 (analog output only) |
| REFCFGL | Lower 4 band-gap configuration/calibration parameters |