IRXM_EN=dis, SCL_OUT=drive_scl_low, MST_MODE=slave_mode, SDA_OUT=drive_sda_low, EN=dis, READ=write, BB_MODE=outputs_disable, ONE_MST_MODE=dis, CLKSTR_DIS=en, IRXM_ACK=ack, GC_ADDR_EN=dis
Control Register0.
| EN | I2C Enable. 0 (dis): Disable I2C. 1 (en): enable I2C. |
| MST_MODE | Master Mode Enable. 0 (slave_mode): Slave Mode. 1 (master_mode): Master Mode. |
| GC_ADDR_EN | General Call Address Enable. 0 (dis): Ignore Gneral Call Address. 1 (en): Acknowledge general call address. |
| IRXM_EN | Interactive Receive Mode. 0 (dis): Disable Interactive Receive Mode. 1 (en): Enable Interactive Receive Mode. |
| IRXM_ACK | Data Acknowledge. This bit defines the acknowledge bit returned by the I2C receiver while IRXM = 1 HW forces ACK to 0 when IRXM = 0. 0 (ack): return ACK (pulling SDA LOW). 1 (nack): return NACK (leaving SDA HIGH). |
| SCL_OUT | SCL Output. This bits control SCL output when SWOE =1. 0 (drive_scl_low): Drive SCL low. 1 (release_scl): Release SCL. |
| SDA_OUT | SDA Output. This bits control SDA output when SWOE = 1. 0 (drive_sda_low): Drive SDA low. 1 (release_sda): Release SDA. |
| SCL | SCL status. This bit reflects the logic gate of SCL signal. |
| SDA | SDA status. THis bit reflects the logic gate of SDA signal. |
| BB_MODE | Software Output Enable. 0 (outputs_disable): I2C Outputs SCLO and SDAO disabled. 1 (outputs_enable): I2C Outputs SCLO and SDAO enabled. |
| READ | Read. This bit reflects the R/W bit of an address match (AMI = 1) or general call match (GCI = 1). This bit is valid 3 cycles after the relevant interrupt bit is set. 0 (write): Write. 1 (read): Read. |
| CLKSTR_DIS | This bit will disable slave clock stretching when set. 0 (en): Slave clock stretching enabled. 1 (dis): Slave clock stretching disabled. |
| ONE_MST_MODE | SCL Push-Pull Mode. This bit controls whether SCL is operated in a the I2C standard open-drain mode, or in a non-standard push-pull mode where the Hi-Z output isreplaced with Drive-1. The non-standard mode should only be used when operating as a master and communicating with slaves that are guaranteed to never drive SCL low. 0 (dis): Standard open-drain operation: drive low for 0, Hi-Z for 1 1 (en): Non-standard push-pull operation: drive low for 0, drive high for 1 |
| HS_EN | High speed mode enable |