MMS=B_0x0, TI1S=B_0x0, CCDS=B_0x0
control register 2
| CCDS | Capture/compare DMA selection 0 (B_0x0): CCx DMA request sent when CCx event occurs 1 (B_0x1): CCx DMA requests sent when update event occurs |
| MMS | Master mode selection These bits permit to select the information to be sent in master mode to slave timers for synchronization (TRGO). The combination is as follows: When the Counter Enable signal is controlled by the trigger input, there is a delay on TRGO, except if the master/slave mode is selected (see the MSM bit description in TIMx_SMCR register). Note: The clock of the slave timer or ADC must be enabled prior to receive events from the master timer, and must not be changed on-the-fly while triggers are received from the master timer. 0 (B_0x0): Reset - the UG bit from the TIMx_EGR register is used as trigger output (TRGO). If the reset is generated by the trigger input (slave mode controller configured in reset mode) then the signal on TRGO is delayed compared to the actual reset. 1 (B_0x1): Enable - the Counter enable signal, CNT_EN, is used as trigger output (TRGO). It is useful to start several timers at the same time or to control a window in which a slave timer is enabled. The Counter Enable signal is generated by a logic AND between CEN control bit and the trigger input when configured in gated mode. 2 (B_0x2): Update - The update event is selected as trigger output (TRGO). For instance a master timer can then be used as a prescaler for a slave timer. 3 (B_0x3): Compare Pulse - The trigger output send a positive pulse when the CC1IF flag is to be set (even if it was already high), as soon as a capture or a compare match occurred. (TRGO) 4 (B_0x4): Compare - OC1REFC signal is used as trigger output (TRGO) 5 (B_0x5): Compare - OC2REFC signal is used as trigger output (TRGO) 6 (B_0x6): Compare - OC3REFC signal is used as trigger output (TRGO) 7 (B_0x7): Compare - OC4REFC signal is used as trigger output (TRGO) |
| TI1S | TI1 selection 0 (B_0x0): The TIMx_CH1 pin is connected to TI1 input 1 (B_0x1): The TIMx_CH1, CH2 and CH3 pins are connected to the TI1 input (XOR combination) See also |