FLASH status register
| EOP | End of operation Set by hardware when one or more flash memory operation (programming / erase) has been completed successfully. This bit is set only if the end of operation interrupts are enabled (EOPIE=1). Cleared by writing 1. |
| OPERR | Operation error Set by hardware when a flash memory operation (program / erase) completes unsuccessfully. This bit is set only if error interrupts are enabled (ERRIE=1). Cleared by writing 1. |
| PROGERR | Programming error Set by hardware when a double-word address to be programmed contains a value different from ‘0xFFFF FFFF’ before programming, except if the data to write is ‘0x0000 0000’. Cleared by writing 1. |
| WRPERR | Write protection error Set by hardware when an address to be erased/programmed belongs to a write-protected part (by WRP, PCROP or RDP Level 1) of the flash memory. Cleared by writing 1. |
| PGAERR | Programming alignment error Set by hardware when the data to program cannot be contained in the same double word (64-bit) flash memory in case of standard programming, or if there is a change of page during fast programming. Cleared by writing 1. |
| SIZERR | Size error Set by hardware when the size of the access is a byte or half-word during a program or a fast program sequence. Only double word programming is allowed (consequently: word access). Cleared by writing 1. |
| PGSERR | Programming sequence error Set by hardware when a write access to the flash memory is performed by the code while PG or FSTPG have not been set previously. Set also by hardware when PROGERR, SIZERR, PGAERR, WRPERR, MISSERR or FASTERR is set due to a previous programming error. Cleared by writing 1. |
| MISSERR | Fast programming data miss error In Fast programming mode, 16 double words (128 bytes) must be sent to flash memory successively, and the new data must be sent to the logic control before the current data is fully programmed. MISSERR is set by hardware when the new data is not present in time. Cleared by writing 1. |
| FASTERR | Fast programming error Set by hardware when a fast programming sequence (activated by FSTPG) is interrupted due to an error (alignment, size, write protection or data miss). The corresponding status bit (PGAERR, SIZERR, WRPERR or MISSERR) is set at the same time. Cleared by writing 1. |
| RDERR | PCROP read error Set by hardware when an address to be read belongs to a read protected area of the flash memory (PCROP protection). An interrupt is generated if RDERRIE is set in FLASH_CR. Cleared by writing 1. |
| OPTVERR | Option and Engineering bits loading validity error |
| BSY1 | Busy This flag indicates that a flash memory operation requested by FLASH control register (FLASH_CR) is in progress. This bit is set at the beginning of the flash memory operation, and cleared when the operation finishes or when an error occurs. |
| CFGBSY | Programming or erase configuration busy. This flag is set and cleared by hardware. It is set when the first word is sent for program or when setting the STRT bit of FLASH control register (FLASH_CR) for erase. It is cleared when the flash memory program or erase operation completes or ends with an error. When set, launching any other operation through the FLASH control register (FLASH_CR) is impossible, and must be postponed (a programming or erase operation is ongoing). When cleared, the program and erase settings in the FLASH control register (FLASH_CR) can be modified. |