fractional part of the multiplication factor for PLL2 VCO
Set and reset by software to control the fractional part of the multiplication factor of the VCO. These bits can be written at any time, allowing dynamic fine-tuning of the PLL2 VCO.
The software must set correctly these bits to insure that the VCO output frequency is between its valid frequency range, that is:
- 128 to 560 MHz if PLL2VCOSEL = 0
- 150 to 420 MHz if PLL2VCOSEL = 1
VCO output frequency = Fref2_ck x (PLL2N + (PLL2FRACN / 213)), with
- PLL2N between 8 and 420
- PLL2FRACN can be between 0 and 213- 1
- The input frequency Fref2_ck must be between 1 and 16 MHz.
To change the PLL2FRACN value on-the-fly even if the PLL is enabled, the application must proceed as follows:
- Set the bit PLL2FRACEN to 0
- Write the new fractional value into PLL2FRACN
- Set the bit PLL2FRACEN to 1