DSIPDEN=B_0x0, RRS=B_0x0, EIWUL=B_0x0
Power control register 3
| EWUP1 | Enable Wakeup pin WKUP1 When this bit is set, the external wakeup pin WKUP1 is enabled and triggers a wakeup from Standby or Shutdown event when a rising or a falling edge occurs. The active edge is configured via the WP1 bit in the PWR_CR4 register. |
| EWUP2 | Enable Wakeup pin WKUP2 When this bit is set, the external wakeup pin WKUP2 is enabled and triggers a wakeup from Standby or Shutdown event when a rising or a falling edge occurs. The active edge is configured via the WP2 bit in the PWR_CR4 register. |
| EWUP3 | Enable Wakeup pin WKUP3 When this bit is set, the external wakeup pin WKUP3 is enabled and triggers a wakeup from Standby or Shutdown event when a rising or a falling edge occurs. The active edge is configured via the WP3 bit in the PWR_CR4 register. |
| EWUP4 | Enable Wakeup pin WKUP4 When this bit is set, the external wakeup pin WKUP4 is enabled and triggers a wakeup from Standby or Shutdown event when a rising or a falling edge occurs. The active edge is configured via the WP4 bit in the PWR_CR4 register. |
| EWUP5 | Enable Wakeup pin WKUP5 When this bit is set, the external wakeup pin WKUP5 is enabled and triggers a wakeup from Standby or Shutdown event when a rising or a falling edge occurs.The active edge is configured via the WP5 bit in the PWR_CR4 register. |
| RRS | SRAM2 retention in Standby mode For STM32L4Rxxx and STM32L4Sxxx devices bit 9 is reserved For STM32L4P5xx and STM32L4Q5xx devices: 0 (B_0x0): SRAM2 is powered off in Standby mode (SRAM2 content is lost). 1 (B_0x1): Full SRAM2 is powered by the low-power regulator in Standby mode (SRAM2 full content is kept). 2 (B_0x2): Only 4 Kbytes of SRAM2 is powered by the low-power regulator in Standby mode (4 Kbytes of SRAM2 content is kept) |
| APC | Apply pull-up and pull-down configuration When this bit is set, the I/O pull-up and pull-down configurations defined in the PWR_PUCRx and PWR_PDCRx registers are applied. When this bit is cleared, the PWR_PUCRx and PWR_PDCRx registers are not applied to the I/Os, instead the I/Os will be in floating mode during Standby or configured according GPIO controller GPIOx_PUPDR register during Run mode. |
| ENULP | Enable ULP sampling When this bit is set, the BORL, BORH and PVD are periodically sampled instead continuous monitoring to reduce power consumption. Fast supply drop between two sample/compare phases is not detected in this mode. This bit has impact only on STOP2, Standby and shutdown low power modes. Note: Available on STM32L4P5xx andSTM32L4Q5xx only. |
| DSIPDEN | Enable Pull-down activation on DSI pins 0 (B_0x0): Pull-Down is disabled on DSI pins. 1 (B_0x1): Pull-Down is enabled on DSI pins. |
| EIWUL | Enable internal wakeup line 0 (B_0x0): Internal wakeup line disable. 1 (B_0x1): Internal wakeup line enable. |