DAC control register
| EN1 | DAC channel1 enable This bit is set and cleared by software to enable/disable DAC channel1. |
| TEN1 | DAC channel1 trigger enable |
| TSEL10 | TSEL10 |
| TSEL11 | TSEL11 |
| TSEL12 | TSEL12 |
| TSEL13 | TSEL13 |
| WAVE1 | DAC channel1 noise/triangle wave generation enable These bits are set and cleared by software. Note: Only used if bit TEN1 = 1 (DAC channel1 trigger enabled). |
| MAMP1 | DAC channel1 mask/amplitude selector These bits are written by software to select mask in wave generation mode or amplitude in triangle generation mode. = 1011: Unmask bits[11:0] of LFSR/ triangle amplitude equal to 4095 |
| DMAEN1 | DAC channel1 DMA enable This bit is set and cleared by software. |
| DMAUDRIE1 | DAC channel1 DMA Underrun Interrupt enable This bit is set and cleared by software. |
| CEN1 | DAC Channel 1 calibration enable This bit is set and cleared by software to enable/disable DAC channel 1 calibration, it can be written only if bit EN1=0 into DAC_CR (the calibration mode can be entered/exit only when the DAC channel is disabled) Otherwise, the write operation is ignored. |
| HFSEL | HFSEL |
| EN2 | DAC channel2 enable This bit is set and cleared by software to enable/disable DAC channel2. |
| TEN2 | DAC channel2 trigger enable |
| TSEL20 | TSEL20 |
| TSEL21 | TSEL21 |
| TSEL22 | TSEL22 |
| TSEL23 | TSEL23 |
| WAVE2 | DAC channel2 noise/triangle wave generation enable These bits are set/reset by software. 1x: Triangle wave generation enabled Note: Only used if bit TEN2 = 1 (DAC channel2 trigger enabled) |
| MAMP2 | DAC channel2 mask/amplitude selector These bits are written by software to select mask in wave generation mode or amplitude in triangle generation mode. = 1011: Unmask bits[11:0] of LFSR/ triangle amplitude equal to 4095 |
| DMAEN2 | DAC channel2 DMA enable This bit is set and cleared by software. |
| DMAUDRIE2 | DAC channel2 DMA underrun interrupt enable This bit is set and cleared by software. |
| CEN2 | DAC Channel 2 calibration enable This bit is set and cleared by software to enable/disable DAC channel 2 calibration, it can be written only if bit EN2=0 into DAC_CR (the calibration mode can be entered/exit only when the DAC channel is disabled) Otherwise, the write operation is ignored. |