T13TED=No_action, T13TEC=No_action, T12SSC=DISABLED, T13RSEL=DISABLED, T12RSEL=DISABLED, T13SSC=No_action
Timer control 2 register
| T12SSC | Timer T12 single shot control 0 (DISABLED): The single-shot mode is disabled, no hardware action on T12R 1 (ENABLED): The single shot mode is enabled, the bit T12R is reset by hardware if: |
| T13SSC | Timer T13 single shot control 0 (No_action): No hardware action on T13R 1 (ENABLED): The single-shot mode is enabled, the bit T13R is reset by hardware if T13 reaches its period value. In parallel to the reset action of bit T13R, the bit CC63ST is reset |
| T13TEC | T13 trigger event control 0 (No_action): No action 1 (Channel_0): Set T13R on a T12 compare event on channel 0 2 (Channel_1): Set T13R on a T12 compare event on channel 1 3 (Channel_2): Set T13R on a T12 compare event on channel 2 4 (Channel_0_1_2): Set T13R on any T12 compare event on the channels 0, 1, or 2 5 (Period_match): Set T13R upon a period-match of T12 6 (Zero_match): Set T13R upon a zero-match of T12 (while counting up) 7 (CCPOSx): Set T13R on any edge of inputs CCPOSx |
| T13TED | Timer T13 trigger event direction 0 (No_action): No action 1 (Up): While T12 is counting up 2 (Down): While T12 is counting down 3 (Independent): Independent on the count direction of T12 |
| T12RSEL | Timer T12 external run selection 0 (DISABLED): The external setting of T12R is disabled 1 (Rising_edge): Bit T12R is set if a rising edge of signal T12HR is detected 2 (Falling_edge): Bit T12R is set if a falling edge of signal T12HR is detected 3 (Edge): Bit T12R is set if an edge of signal T12HR is detected |
| T13RSEL | Timer T13 external run selection 0 (DISABLED): The external setting of T13R is disabled 1 (Rising_edge): Bit T13R is set if a rising edge of signal T13HR is detected 2 (Falling_edge): Bit T13R is set if a falling edge of signal T13HR is detected 3 (Edge): Bit T13R is set if an edge of signal T13HR is detected |