T3UD=UP, T3R=STOP, T3M=TIMER_MODE, T3EDGE=NO_COUNT, BPS1=8, T3OE=DISABLED, T3UDE=T3UD, T3DIR=UP, T3CHDIR=NO_CHANGE
Timer T3 control register
T3I | Timer T3 input parameter selection |
T3M | Timer T3 input mode control 0 (TIMER_MODE): Timer mode 1 (COUNTER_MODE): Counter mode 2 (GATED_LOW): Gated timer mode with gate active low 3 (GATED_HIGH): Gated timer mode with gate active high 6 (INCREMENTAL_INTERFACE_MODE): Rotation detection mode 7 (INCREMENTAL_INTERFACE_MODE): Edge detection mode |
T3R | Timer T3 input run bit 0 (STOP): Timer T3 stops 1 (RUN): Timer T3 runs |
T3UD | Timer T3 up/down control 0 (UP): Timer T3 counts up 1 (DOWN): Timer T3 counts down |
T3UDE | Timer T3 external up/down enable 0 (T3UD): Count direction is controlled by bit T3UD; input T3EUD is disconnected 1 (T3EUD): Count direction is controlled by input T3EUD |
T3OE | Overflow/underflow output enable 0 (DISABLED): Alternate output function disabled 1 (T3OUT): State of T3 toggle latch is output on pin T3OUT |
T3OTL | Timer T3 overflow toggle latch |
BPS1 | GPT1 block prescaler control 0 (8): fGPT/8 1 (4): fGPT/4 2 (32): fGPT/32 3 (16): fGPT/16 |
T3EDGE | Timer T3 edge detection flag 0 (NO_COUNT): No count edge was detected 1 (COUNT): A count edge was detected |
T3CHDIR | Timer T3 count direction change flag 0 (NO_CHANGE): No change of count direction was detected 1 (CHANGE): A change of count direction was detected |
T3DIR | Timer T3 rotation direction flag 0 (UP): Timer T3 counts up 1 (DOWN): Timer T3 counts down |