Control Register
| MON_ENA | Enable the DVS monitoring circuit |
| ADJ_ENA | Enable the power supply adjustment based on measurements |
| PS_FB_DIS | Power Supply Feedback Disable |
| CTRL_TAP_ENA | Use the TAP Select for automatic adjustment or monitoring |
| PROP_DLY | Additional delay to monitor lines |
| MON_ONESHOT | Measure delay once |
| GO_DIRECT | Operate in automatic mode or move directly |
| DIRECT_REG | Step incrementally to target voltage |
| PRIME_ENA | Include a delay line priming signal before monitoring |
| LIMIT_IE | Enable Limit Error Interrupt |
| RANGE_IE | Enable Range Error Interrupt |
| ADJ_IE | Enable Adjustment Error Interrupt |
| REF_SEL | Select TAP used for voltage adjustment |
| INC_VAL | Step size to increment voltage when in automatic mode |
| DVS_PS_APB_DIS | Prevent the application code from adjusting Vcore |
| DVS_HI_RANGE_ANY | Any high range signal from a delay line will cause a voltage adjustment |
| FB_TO_IE | Enable Voltage Adjustment Timeout Interrupt |
| FC_LV_IE | Enable Low Voltage Interrupt |
| PD_ACK_ENA | Prevent DVS from ack’ing a request to enter a low power mode until in the idle state |
| ADJ_ABORT | Causes the DVS to enter the idle state immediately on a request to enter a low power mode |