EVENT=NONE, ACTSTATE=NORMAL, TIMECTRL=DIS
Target Status Register.
| BUSY | Not stopped. |
| LIST_RESP | Message status - listening/responding or not. |
| CCCH | CCC is being handled. |
| RX_SDR | SDR Read. |
| TX_SDR | SDR Write. |
| DAA | Dynamic Address Assignment Mode. |
| HDR | HDR Mode. |
| START | START Detected. |
| ADDRMATCH | Address Matched. |
| STOP | STOP Detected. |
| RX_RDY | Receive data ready. |
| TX_NFULL | TX FIFO is not full, ready to accept more data. |
| DYNADDR_CHG | Dynamic address changed. |
| CCC | CCC received. |
| ERRWARN | An error or warning has occurred. |
| CCCH_DONE | CCC Handled. |
| EVENT_REQ | Event Requested. |
| TARG_RST | Target Reset. |
| EVENT | Event Status. 0 (NONE): No event. 1 (REQ_PEND): Request not yet sent. 2 (REQ_NACK): Request was sent and NACKed and will be tried again. 3 (REQ_ACK): Request was sent and ACKed. |
| IBI_DIS | Indicates whether IBI events are disabled. |
| CONTREQ_DIS | Indicates whether bus controller request events are disabled. |
| HJ_DIS | Indicates whether Hot-Joinevents are disabled. |
| ACTSTATE | Holds the current activity state. 0 (NORMAL): No latency, normal bus operation. 1 (1MS_LAT): 1 ms latency. 2 (100MS_LAT): 100 ms latency. 3 (10S_LAT): 10 s latency. |
| TIMECTRL | Time Control mode. 0 (DIS): No timing control mode is enabled. 1 (SYNC): Synchronous Mode is enabled. 2 (ASYNC): Asynchronous Mode is enabled. 3 (BOTH): Both synchronous and asynchronous modes are enabled. |