GPIO_WE=dis, MODE=active, ISO_PD=active
Power Management.
| MODE | Operating Mode. This two bit field selects the current operating mode for the device. Note that code execution only occurs during ACTIVE mode. 0 (active): Active Mode. 1 (sleep): Cortex-M4 Active, RISC-V Sleep Mode. 2 (standby): Standby Mode. 4 (backup): Backup Mode. 8 (lpm): LPM or CM4 Deep Sleep Mode. 9 (upm): UPM. 10 (powerdown): Power Down Mode. |
| GPIO_WE | GPIO Wake Up Enable. This bit enables all GPIO pins as potential wakeup sources. Any GPIO configured for wakeup is capable of causing an exit from IDLE or STANDBY modes when this bit is set. 0 (dis): Wake Up Disable. 1 (en): Wake Up Enable. |
| RTC_WE | RTC Alarm Wake Up Enable. This bit enables RTC alarm as wakeup source. If enabled, the desired RTC alarm must be configured via the RTC control registers. |
| USB_WE | USB Wake Up Enable. This bit enables USB IRQ as wakeup source |
| WUT_WE | WUT Wake Up Enable. This bit enables the Wake-Up Timer as wakeup source. |
| AINCOMP_WE | AIN COMP Wake Up Enable. This bit enables AIN COMP as wakeup source. |
| ISO_PD | 60 MHz power down. This bit selects the 60 MHz clock power state in DEEPSLEEP mode. 0 (active): Mode is Active. 1 (deepsleep): Powered down in DEEPSLEEP. |
| IPO_PD | 100 MHz power down. This bit selects 100 MHz clock power state in DEEPSLEEP mode. |
| IBRO_PD | 7.3725 MHz power down. This bit selects 7.3725 MHz clock power state in DEEPSLEEP mode. |
| EBO_BP | EBO Bypass |