COMG=B_0x0, UG=B_0x0, CC1G=B_0x0, BG=B_0x0, TG=B_0x0, B2G=B_0x0
TIM1 event generation register
| UG | Update generation This bit can be set by software, it is automatically cleared by hardware. 0 (B_0x0): No action 1 (B_0x1): Reinitialize the counter and generates an update of the registers. Note that the prescaler counter is cleared too (anyway the prescaler ratio is not affected). The counter is cleared if the center-aligned mode is selected or if DIR=0 (upcounting), else it takes the auto-reload value (TIMx_ARR) if DIR=1 (downcounting). |
| CC1G | Capture/compare 1 generation This bit is set by software in order to generate an event, it is automatically cleared by hardware. If channel CC1 is configured as output: CC1IF flag is set, Corresponding interrupt or DMA request is sent if enabled. If channel CC1 is configured as input: The current value of the counter is captured in TIMx_CCR1 register. The CC1IF flag is set, the corresponding interrupt or DMA request is sent if enabled. The CC1OF flag is set if the CC1IF flag was already high. 0 (B_0x0): No action 1 (B_0x1): A capture/compare event is generated on channel 1: |
| CC2G | Capture/compare 2 generation Refer to CC1G description |
| CC3G | Capture/compare 3 generation Refer to CC1G description |
| CC4G | Capture/compare 4 generation Refer to CC1G description |
| COMG | Capture/compare control update generation This bit can be set by software, it is automatically cleared by hardware Note: This bit acts only on channels having a complementary output. 0 (B_0x0): No action 1 (B_0x1): When CCPC bit is set, it allows to update CCxE, CCxNE and OCxM bits |
| TG | Trigger generation This bit is set by software in order to generate an event, it is automatically cleared by hardware. 0 (B_0x0): No action 1 (B_0x1): The TIF flag is set in TIMx_SR register. Related interrupt or DMA transfer can occur if enabled. |
| BG | Break generation This bit is set by software in order to generate an event, it is automatically cleared by hardware. 0 (B_0x0): No action 1 (B_0x1): A break event is generated. MOE bit is cleared and BIF flag is set. Related interrupt or DMA transfer can occur if enabled. |
| B2G | Break 2 generation This bit is set by software in order to generate an event, it is automatically cleared by hardware. 0 (B_0x0): No action 1 (B_0x1): A break 2 event is generated. MOE bit is cleared and B2IF flag is set. Related interrupt can occur if enabled. |