CMF=B_0x0, RXFF=B_0x0, TXFE=B_0x0, TXFT=B_0x0, CTS=B_0x0, TXFNF=B_0x0, FE=B_0x0, SBKF=B_0x0, CTSIF=B_0x0, RXFNE=B_0x0, PE=B_0x0, RXFT=B_0x0, NE=B_0x0, RWU=B_0x0, BUSY=B_0x0, IDLE=B_0x0
LPUART interrupt and status register
| PE | Parity error 0 (B_0x0): No parity error 1 (B_0x1): Parity error |
| FE | Framing error 0 (B_0x0): No Framing error is detected 1 (B_0x1): Framing error or break character is detected |
| NE | Start bit noise detection flag 0 (B_0x0): No noise is detected 1 (B_0x1): Noise is detected |
| ORE | Overrun error 1 (B_0x1): Overrun error is detected |
| IDLE | Idle line detected 0 (B_0x0): No Idle line is detected 1 (B_0x1): Idle line is detected |
| RXFNE | RXFIFO not empty 0 (B_0x0): Data is not received 1 (B_0x1): Received data is ready to be read. |
| TC | Transmission complete |
| TXFNF | TXFIFO not full 0 (B_0x0): Data register is full/Transmit FIFO is full. 1 (B_0x1): Data register/Transmit FIFO is not full. |
| CTSIF | CTS interrupt flag 0 (B_0x0): No change occurred on the CTS status line 1 (B_0x1): A change occurred on the CTS status line |
| CTS | CTS flag 0 (B_0x0): CTS line set 1 (B_0x1): CTS line reset |
| BUSY | Busy flag 0 (B_0x0): LPUART is idle (no reception) 1 (B_0x1): reception ongoing |
| CMF | Character match flag 0 (B_0x0): No Character match detected 1 (B_0x1): Character match detected |
| SBKF | Send break flag 0 (B_0x0): No break character transmitted 1 (B_0x1): Break character transmitted |
| RWU | Receiver wake-up from mute mode 0 (B_0x0): Receiver in active mode 1 (B_0x1): Receiver in mute mode |
| WUF | Wake-up from low-power mode flag |
| TEACK | Transmit enable acknowledge flag |
| REACK | Receive enable acknowledge flag |
| TXFE | TXFIFO Empty 0 (B_0x0): TXFIFO is not empty. 1 (B_0x1): TXFIFO is empty. |
| RXFF | RXFIFO Full 0 (B_0x0): RXFIFO is not Full. 1 (B_0x1): RXFIFO is Full. |
| RXFT | RXFIFO threshold flag 0 (B_0x0): Receive FIFO does not reach the programmed threshold. 1 (B_0x1): Receive FIFO reached the programmed threshold. |
| TXFT | TXFIFO threshold flag 0 (B_0x0): TXFIFO does not reach the programmed threshold. 1 (B_0x1): TXFIFO reached the programmed threshold. |