REG_EN=B_0x0, CONFIGLOCK=B_0x0, KEYLOCK=B_0x0
OTFDEC region 2 configuration register
| REG_EN | region on-the-fly decryption enable Note: Garbage is decrypted if region context (version, key, nonce) is not valid when this bit is set. 0 (B_0x0): On-the-fly decryption is disabled for this region. 1 (B_0x1): On-the-fly decryption is enabled for this region. Data are XORed with the corresponding keystream. |
| CONFIGLOCK | region config lock Note: This bit is set once. If this bit is set, it can only be reset to 0 if OTFDEC is reset. Setting this bit forces KEYLOCK bit to 1. 0 (B_0x0): Writes to this region OTFDEC_RxCFGR, OTFDEC_RxSTARTADDR, OTFDEC_RxENDADDR and OTFDEC_RxNONCERy registers are allowed. 1 (B_0x1): Writes to this region OTFDEC_RxCFGR, OTFDEC_RxSTARTADDR, OTFDEC_RxENDADDR and OTFDEC_RxNONCERy registers are ignored until next OTFDEC reset. |
| KEYLOCK | region key lock Note: This bit is set once: if this bit is set, it can only be reset to 0 if the OTFDEC is reset. 0 (B_0x0): Writes to this region KEYRx registers are allowed. 1 (B_0x1): Writes to this region KEYRx registers are ignored until next OTFDEC reset. KEYCRC bitfield is locked. |
| MODE | operating mode This bitfield selects the OTFDEC operating mode for this region: Others: Reserved When MODE different 11, the standard AES encryption mode is activated. When either of the MODE bits are changed, the region key and associated CRC are zeroed. 2 (B_0x2): All read accesses are decrypted (instruction or data). 3 (B_0x3): Enhanced encryption mode is activated, and only instruction accesses are decrypted |
| KEYCRC | region key 8-bit CRC When KEYLOCK = 0, KEYCRC bitfield is automatically computed by hardware while loading the key of this region in this exact sequence: KEYR0 then KEYR1 then KEYR2 then finally KEYR3 (all written once). A new computation starts as soon as a new valid sequence is initiated, and KEYCRC is read as zero until a valid sequence is completed. When KEYLOCK = 1, KEYCRC remains unchanged until the next reset. CRC computation is an 8-bit checksum using the standard CRC-8-CCITT algorithm X8 + X2 + X + 1 (according the convention). Source code is available in . This field is read only. Note: CRC information is updated only after the last bit of the key has been written. |
| REGx_VERSION | region firmware version This 16-bit bitfield must be correctly initialized before the region corresponding REG_EN bit is set in OTFDEC_RxCFGR. |