VBVALOVEN=B_0x0, PDEN=B_0x0, DCDEN=B_0x0, HVDMSRCEN=B_0x0, FORCEHOSTPD=B_0x0, SDEN=B_0x0, SESSVLD=B_0x0, FSVPLUS=B_0x0, CHGDET=B_0x0, HCDPEN=B_0x0, FSVMINUS=B_0x0, HCDPDETEN=B_0x0, VBDEN=B_0x0, VBVALOVAL=B_0x0
OTG general core configuration register
| CHGDET | Charger detection, result of the current mode (primary or secondary). 0 (B_0x0): Low value on pin 1 (B_0x1): High value on pin |
| FSVPLUS | Single-Ended DP indicator This bit gives the voltage level on DP (also result of the comparison with VLGC threshold as defined in BC v1.2 standard). 0 (B_0x0): DM voltage at low level 1 (B_0x1): DM voltage at high level |
| FSVMINUS | Single-Ended DM indicator This bit gives the voltage level on DM (also result of the comparison with VLGC threshold as defined in BC v1.2 standard). 0 (B_0x0): DM voltage at low level 1 (B_0x1): DM voltage at high level |
| SESSVLD | VBUS session indicator Indicates if VBUS is above VBUS session threshold. 0 (B_0x0): VBUS is below VBUS session threshold 1 (B_0x1): VBUS is above VBUS session threshold |
| HCDPEN | Host CDP behavior enable 0 (B_0x0): Disable CDP behavior 1 (B_0x1): Enable CDP behavior |
| HCDPDETEN | Host CDP port voltage detector enable on DP 0 (B_0x0): DP voltage detection disabled 1 (B_0x1): DP voltage detection enabled |
| HVDMSRCEN | Host CDP port Voltage source enable on DM 0 (B_0x0): DM voltage source disabled 1 (B_0x1): DM Voltage source enabled |
| DCDEN | Data Contact Detection enable 0 (B_0x0): Data Contact Detection disabled 1 (B_0x1): Data Contact Detection enabled |
| PDEN | Primary detection enable 0 (B_0x0): Primary detection disabled 1 (B_0x1): Primary detection enabled |
| VBDEN | VBUS detection enable Enables VBUS Sensing Comparators in order to detect VBUS presence and/or perform OTG operation. 0 (B_0x0): VBUS detection disabled 1 (B_0x1): VBUS detection enabled |
| SDEN | Secondary detection enable 0 (B_0x0): Secondary detection disabled 1 (B_0x1): Secondary detection enabled |
| VBVALOVAL | Software override value of the VBUS B-session detection 0 (B_0x0): B-session inactive 1 (B_0x1): B-session active |
| VBVALOVEN | Enables a software override of the VBUS B-session detection. 0 (B_0x0): Use hardware 1 (B_0x1): Use VBVALOVAL to indicate B-session active |
| FORCEHOSTPD | Force host mode pull-downs If the ID pin functions are enabled, the host mode pull-downs on DP and DM activate automatically. However, whenever that is not the case, yet host mode is required, this bit must be used to force the pull-downs active. 0 (B_0x0): Do not force host mode pull-downs 1 (B_0x1): Force host mode pull-downs |