PWR apply pull configuration register
| APC | Apply pull-up and pull-down configuration When this bit is set, the I/O pull-up and pull-down configurations defined in PO5_PUPD, PN7_PUPD bits and PUCRx, PDCRx registers are applied in Standby mode even after wakeup until APC bit is reset to 0. When this bit is cleared, the I/O pull-up or pull-down configurations defined in PO5_PUPD, PN7_PUPD bits and PUCRx and PDCRx registers are not applied in Standby mode and IO becomes Hi-Z. |
| PN7_PUPD | Port N bit 7 pull-up/down configuration When this bit is set, a weak pull-up or pull-down resistor is applied on PN7 following inverse logic applied on PN6. If the PUN6 bit in PWR_PUCRN register is set and APC bit is set the week pull-down is applied on PN7. If the PDN6 bit in PWR_PDCRN register is set and APC bit is set the week pull-up is applied on PN7. |
| PO5_PUPD | Port O bit 5 pull-up/down configuration When this bit is set, a weak pull-up or pull down resistor is applied on PO5 following inverse logic applied on PO4. If the PUO4 bit in PWR_PUCRO register is set and APC bit is set the week pull-down is applied on PO5. If the PDO4 bit in PWR_PDCRO register is set and APC bit is set the week pull-up is applied on PO5… |
| I3CPB6_PU | Port PB6 I3C pull-up bit When I3C is used on PB6, when set, this bit activates the pull-up on I3C1_SCL (PB6) in standby mode. |
| I3CPB7_PU | Port PB7 I3C pull-up bit When I3C is used on PB7, when set, this bit activates the pull-up on I3C1_SDA (PB7) in standby mode. |
| I3CPB8_PU | Port PB8 I3C pull-up bit When I3C is used on PB8, when set, this bit activates the pull-up on I3C1_SCL (PB8) in standby mode. |
| I3CPB9_PU | Port PB9 I3C pull-up bit When I3C is used on PB9, when set, this bit activates the pull-up on I3C1_SDA (PB9) in standby mode. |